Animal Hospital 中文攻略｜How to Kill the Ghost Without Burning Your Whole Run
警戒等级: LETHAL
即时指令摘要
- 阅读 How to Kill the Ghost Without Burning Your Whole Run 的快速答案，确认当前页解决的问题。
- 进入游戏后按本页顺序核对入口、任务条件和奖励类型。
- 把已经完成的目标从清单中移除，只保留下一步可执行动作。
1. Recognizing the Threat
The Ghost was added in the June 26, 2026 update and behaves differently from normal intake anomalies: it roams the hospital, can go invisible, drains sanity over time, and does not rely on the usual patient-window inspection loop. It can also attack while invisible, so waiting for a perfect visual is what gets most solo players chipped down.
2. The Safe Kill Sequence
First reveal its position with the fire extinguisher, then stop spraying and immediately switch to a taser or gun. The Fandom page and current community ghost guides agree that extinguisher utility is mostly exposure, while the actual takedown comes from taser or gun; approaching from behind is the most consistent way to prevent another vanish-and-drain cycle.
执行前先检查
- Enter the hallway with a reveal tool ready before you chase the Ghost sound.
- Use a short fire-extinguisher burst to expose the Ghost position.
- Swap to taser or gun after the reveal instead of trying to finish with the spray.
- Close from behind or from a side angle, then reset the route if it vanishes again.
- Leave the room if you have no finisher or your sanity is already low.
什么会毁掉路线
- Holding the fire extinguisher too long and treating it like the kill tool.
- Firing a taser before the Ghost is visible, which wastes the safest finisher window.
- Chasing the last visible position instead of listening for the next door or audio cue.
- Staying in a tight hallway after the reveal fails.
这条路线的快速答案
Does the fire extinguisher kill the Ghost?
No. Use it to reveal the Ghost, then switch to a taser or gun for the actual takedown.
What should I do if the Ghost disappears again?
Back out, listen for the next cue, and re-enter with the extinguisher ready. Do not chase the last spot blindly.
Is it worth fighting the Ghost while low on sanity?
Only if you have a clear reveal and finisher. Otherwise rotate away and stabilize the shift first.